2/4/10PC DC12V Adjustable Time Delay Timing Timer Relay Switch ON/OFF Modules

Description: 2/4/10x DC12V Adjustable Time Delay Timing Timer Relay Switch Turn ON/OFF Modules Description:1. Using high-quality materials, the quality is guaranteed2. There are four delay time ranges, and the delay time can be selected by the switch3. Long service life, can withstand 100,000 times of use4. Its power consumption is very small, less than 1W5. High sensitivity, fast and accurate detection6. Wide range of applications7.Qty:2/4/10pcs Parameter:Voltage: 12VPower consumption: <1.0WOutput: passive output (ie dry contact), a group of relay normally open + normally closed output. The maximum should not exceed 10ATime range: (4 gears, selected by switch)First gear: range 0.2 seconds-30 seconds, accuracy: 0.1 secondsSecond gear: range 0.2 seconds-300 seconds (5 minutes), accuracy: 0.3 secondsThird gear: range 0.2 seconds-30 minutes, accuracy: 1.8 secondsFourth gear: range 0.2 seconds-300 minutes (5 hours), accuracy: 18 secondsLifespan: 100,000 actionsInput: voltage signal, valid signal above 1.5V, current needs at least 0.1mA Module voltage: 12V DC: The power requirements of the module, the range is 10V-16V, it must be DC Package list:2/4/10x Delay Relay Modules Terminal:Positive pole of DC power supply of V+ moduleThe negative pole of the DC power supply of the GND module is also the reference GND of the signal voltage.IN signal voltage input, low level below 1V, high level above 1.5V, and indeterminate in the middle. Withstands up to 30VNO relay normally open contactFrequently contacted contacts of NC relaysCOM relay contact common terminal Instructions:Time range setting:When the selector switch is placed in the 30 position, it means 0-30 is adjustableWhen the selector switch is placed in the 300 position, it means 0-300 is adjustableAdjustment of time value:Turn the adjustable resistor counterclockwise in the - direction to decrease the time, and turn it clockwise in the + direction to increase the timeTime unit setting:When the selector switch is in the Sec position, the unit is: secondsWhen the selector switch is in the Min position, the unit is: minutes Example:Request a 50-minute delay:1. The scope is placed at the 300 position2. The time unit is placed in the Min position3. Adjust the adjustable resistance to the 50 position, and the full adjustment is 300, so the adjustment to 1/5 is 50.Note: The adjustment of the potentiometer can also be quickly adjusted with the voltage gear of the multimeter. For example, the range of 30 needs to be adjusted to 12, then the voltage can be adjusted to 2.t=Ut/5*30=2.0V / 5.0V * 30 =12Ut is the voltage measured by the multimeter, 30 is the range selected by the selector switch, and it can also be selected to 300 On Nov 8, 2024 at 04:31:48 PST, seller added the following information:

Price: 15.89 USD

Location: Bordentown, New Jersey

End Time: 2025-01-08T10:09:07.000Z

Shipping Cost: 0 USD