Description: 40A/60A/100A MPPT Solar Charge Controller 12V/24V/36V/48V PV Battery Regulator #2641-2642-2643 MPPT -40A/60A/100A-12V/24V: MPPT solar charge controller: Compared with normal solar charge controller, this MPPT controller could increase efficiency by 10%-30%. Automatic focusing MPPT tracking charging, high charging efficiency, non-stop detection during charging, bidirectional focusing tracking. Large-screen LCD display, adjustable charging and discharging parameters. This MPPT controller has perfect SOC function, control charge current, and supply power to the loads. Prevent the battery from over-charging, over-discharging and reverse charging to solar panels during nights. How To Use Q&A 1. Q: How many watts (W) of solar panels can be connected to 30A, and 60A? A: 10A Within 240W, 20A Within 480W, 30A Within 720W, 40A Within 960W, 50A Within 1200W, 60A within 1440W, 100A Within 1680W 2. Q: Does this controller support lithium batteries? A: The new controller(MPPT) is available with lead acid and lithium batteries, others not. 3. Q: My solar panel is 36V 200W, can I charge 12V battery? A: For 12V battery, solar panel working voltage can be between 17V and 23V; For 24V battery, solar panel working voltage can be between 36V and 46V. Please confirm that the power and Solar panel working voltage the are within this range. If it's too high, it will damage the controller. 4. Q: Can the inverter be connected to the load side of the controller? A: Please connect the inverter directly to the battery and not to the load terminal of the controller. 5. Q: Does the controller have a requirement for battery capacity? A: No, as long as the voltage corresponds to it (but the maximum current of the board and the battery capacity should correspond). For example, the current of the solar panel is 5 amps, the battery capacity is preferably 50 AH, the current of the solar panel is 10 A, and the battery capacity is preferably 100 AH. Do not use a large board to charge a small battery, which may be dangerous. 6. Q: How do you connect the solar panels, batteries, and controllers? A: Please be sure to connect the battery first (to ensure that the battery is fully charged), then connect the solar panel. When disassembling, please remove the solar panel first, then remove the battery, please connect it exactly as this order, otherwise the controller and other components probably damaged. Others 1. Always keep the battery on fill voltage condition. 2. Prevent the battery from over-charging. 3. Prevent the battery from over-discharging. 4. Prevent the battery from reverse charging to solar panels during nights. 5. Reverse Polarity Protection for Battery 6. Reverse Polarity Protection for Solar Panels 7. When the battery voltage is low, the controller will automatically cut off the load from the system. If the voltage of battery is back to normal and the load will restart working. 8. Thunder protection 9. According to the battery voltage grade, the controller can automatically set charge-off voltage, the load-off voltage, the load- restore voltage. (The parameter is default under 25 condition, locked by the CPU procedure, cannot adjust.) 10. The controller will automatically compensate the temperature of the charging voltage according to the changes of ambient temperature. Product Specification Rated voltage: 12/24V Rated current: 30/40/60/100A Max. PV voltage: 50V Max. PV input power: 750W(12V) / 1500W(24V) Package Included 1 x Solar Panels Battery Charge Controller 1 x User Manual #11901 MPPT - 100A-12V/24V/36V/48V: - LCD Liquid Crystal Display: The solar charging controller adopts an LCD liquid crystal display with backlight display, which can be clearly and intuitively displayed in the dark, one-key operation of the panel keys can adjust various system control parameters, such as float charging voltage, boost charging voltage, light control and time delay, etc. - Multiple Operating Modes: This solar charge controller has seven operating modes, such as charging mode, light control mode, light and time delay control mode, universal control mode, manual control mode, timing control mode and testing mode, among them, test mode is only available to the factory test. - Large-section Wiring Port: use large-section, large-spacing wiring ports, can be installed 16mm wire, the wire spacing of 7mm increases the insulation performance and the reliability of installation, effectively reduces current and voltage drop while reducing losses. - Dual USB Charging Ports: The solar charge controller adopts a dual USB charging port design, which can charge two devices at the same time, and supports most of USB port devices, such as mobile phones, tablets, PSP game consoles, etc. - Thickened Aluminum Alloy Heat Sink: The MOS tube is used to lock the heat sink design, the heat dissipation is more uniform, and there is no fear of the temperature rise caused by the MOS tube, the powerful heat dissipation capacity can operate normally in the environment of 55 ℃, at the same time, it is equipped with functions to prevent overcharge, overvoltage, DC output low voltage, high voltage protection and reverse polarity protection, etc. Specification: Model: SY-12/24/36/48V100A Colour: Black Maximum charging current: 100A Maximum input voltage of photovoltaic panels: 23V (12V), 45V (24V), 69V (36V), 90V (48V) Maximum input power of photovoltaic panels: 1000W (12V), 2000W (24V), 3000W (36V), 4000W (48V) Output voltage: DC12V/24V/36V/48V; DC5V/1.5Ax2USB Working temperature: -25℃~55℃ Cooling method: heat sink self-cooling Charging method: Focused MPPT modulation charging Working mode: seven Protection function: prevent overcharge, overvoltage/DC output low voltage, high voltage protection, reverse polarity protection, etc. Product size (L*W*H): 195*183*68mm/7.68*7.20*2.68inch Package size (L*W*H): 205*205*70mm/8.07*8.07*2.76inch Package includes: 1 x Solar Charge Controller 1 x Manual PaymentsDelivery detailsReturn and exchangeFeedback & RatingContact usPaymentsPayments: Paypal, Google Pay, Visa, Master Card, Amerian Express, Discover. Delivery detailsAll items are shipped from US warehouse located at NJ. We ship to your eBay or Paypal address. Please make sure your eBay or Paypal address is correct before you pay. Return and exchangeFree returnFeedback & RatingPls contact our customer service firstly if have any problems , we will help to solve the issue, and could offer free return service for full refund or free replacement after confirming. You can buy from us with confidence Contact usIf have any problems, please feel free to contact us.
Price: 24.75 USD
Location: Sayreville, New Jersey
End Time: 2024-07-29T10:00:34.000Z
Shipping Cost: 0 USD
Product Images
Item Specifics
Restocking Fee: No
Return shipping will be paid by: Seller
All returns accepted: Returns Accepted
Item must be returned within: 60 Days
Refund will be given as: Money back or replacement (buyer's choice)
Current Rating: 10-100A
Current Type: Solar Panel Regulator
System Configuration: 30
Material: Metal
Power Source: Solar
Type: Solar Panel Controller
Features: Auto Focus Tracking
MPN: Does not apply
Power: 750W(12V)/ 1500W(24V)
Current Output: 30-100A
Brand: MUCH
Application: Home, Industrial, Commercial
Charging Mode: 30/40/60 / 100A
Device Type: MPPT Charge Controller
Rated Current: 30A/40A/60A/100A
Rated Voltage: 12V/24V
Resistance Properties: 100
Voltage: 12 / 24V
Model: no
Available Variations
Color: MPPT - 100A-12V/24V/36V/48V
Price: 75.79 USD
Available Quantity: 39
Quantity Sold: 0
Color: MPPT -100A-12V/24V
Price: 36.71 USD
Available Quantity: 30
Quantity Sold: 0
Color: MPPT -60A-12V/24V
Price: 28.61 USD
Available Quantity: 28
Quantity Sold: 0
Color: MPPT -40A-12V/24V
Price: 24.75 USD
Available Quantity: 30
Quantity Sold: 0