58083 M7 Heater Assembly Replacement Heater for Balboa BP, VS, & EL2001 220V

Description: Applicability This heater is suitable for Balboa BP Series control systems, such as BP501G1, BP501G3, BP2000G1, BP7, as well as for Balboa VS Series and EL2001 Series control systems, such as VS501Z, VS510SZ, VS520SZ, and EL2001M3. Multiple Model Replacements It can replace multiple models, including 2-00-7028, 58306, 58306KIT, 58083, 58083K, 26-58083-7S-KS, 26-0807-7S-KS, 2-00-0036C, C2550-0807-TPS, 58209, 58000, 58010, 58123, 58089, 58086, 58105, or X300930, 46-138-1020, 58016, 55473, 58140, 740-0617, 740-0655, 2-00-0049, 55624 Master Spas X300713, 58016, 25-250-0807, 25-200-8083, 26-58083-K, Artesia OP24-0216-08, 25-200-0001, 58237 (5.5KW 825 15IN 1.5 inch), 25-175-1010, and others. Important Specification Heater Length: 15", Heater Diameter: 2". 5.5KW, 220V heater element. Please choose correct rated heater for replacement and put it in right position to extend the service life of the device. High-Quality Materials Equipped with a 316 stainless steel heater housing and a 5.5KW Incoloy Flo-Thru heater element, it also supports Balboa OEM M7 dual sensors. Easy to Use The 58083 M-7 Heater Assembly can be used as a replacement heater for spas or hot tubs, featuring its own sensors, front-mounted design for user convenience, and easy servicing. Wide Application Suitable for most Balboa heater. Replace the following part numbers (but not limited to)Balboa:58282, 55302, 55473, 58002, 58016, 58086, 58089, 58090, 58121, 58123, 58140, 58209, 58306Cal Spa:HEA14100450HydroQuip:26-0807-7S-KS, 25-58002-K, 26-58083-K, Therm Products C2500-0807-TPS Step 1 Disconnect the power supply of the equipment. Use an open end wrench to slowly crack the heater split nuts until the water in the pipe flows out Step 2 Locate the 2 sensors holder on the circuit board. Remove the 2 heater sensors by depressing the clip and gently pulling on the wire to remove each sensor cable Step 3 Use a 3/8” wrench to remove the 2 nuts holding the heater in place Step 4 Use a 3/8” wrench to remove the nuts on the copper straps. Then lift the copper straps Step 5 Use an open end wrench to loosen the heater split nuts and remove the old heater assembly and gaskets Step 6 Replace the new gaskets and install the new heater assembly, tighten the split nuts with an open end wrench. Step 7 Screw on the 2 nuts that holding the heater, insert the 2 heater sensors into the sensor bracket on the circuit board, make sure the copper strip is connected to the heater and tighten the nuts. Step 8 Put the cover on and screw on the 2 screws on the top of the enclosure. Turn on the water valve and pump, restore the power of the equipment, and test

Price: 134.9 USD

Location: Rancho Cucamonga, California

End Time: 2024-02-14T13:49:18.000Z

Shipping Cost: 0 USD