Blank Key Holder Wall Mount 11" X 5" w/4 Hooks

Description: This is a brand new in box blank wall mounted key hanger with 4 brass hooks. This key hanger measures 11" wide x 5" high x .625" thick. This key hanger is blank so you can customize by either painting it or using sublimation. If you use sublimation, instructions:UNISUB KEY HANGER SUBLIMATION Supplies needed: - sublimatable substrate - sublimation transfer - teflon or scratch paper - lighter fluid - repostionable adhesive spray - (3M75) - soft paper towel (optional) Heat press settings: - temperature - 385 degrees F - dwell time - 1 min & 45 seconds - 2 minutes - pressure - medium Note: The recommended settings above may need adjustments for best results. Settings will vary depending on the heat press brand and model ink and paper and atmospheric conditions. 2nd Note: The layers of soft paper towel achieve two goals: 1. it helps to distribute the pressure evenly throughout the substrate; 2. it helps to trap ink that is dispersed outside of the edges of the substrate if there is an overprint area or full bleed in the artwork. 3rd Note: Clam-shell presses are not recommended for use with thick items such as the plaques. A swing-away press is recommended. Layer the press from the bottom pad to the top heat platen as follows: 1. teflon sheet or scratch paper 2. 2-3 layers of soft paper towel 3. plaque facing up with transfer facing down on plaque 4. teflon sheet or scratch paper Steps: 1. Remove the protective plastic coating if any from the substrate 2. Use soft paper towel with lighter fluid on it and then wipe face and edges of front of plaque to remove any excess foil residue 3. Lightly spray transfer with repositionable adhesive spray 4. Adhere transfer to plaque 5. Place the transfer and substrate in the press onto the paper towel (transfer on top of substrate). 5. Place the teflon sheet or scratch paper over the transfer. 6. Press the items using the settings listed above. 7. Remove items from the press immediately. Use heat resistant gloves if necessary - the items will be very hot. 8. Remove transfer from plaque 9. Once cool use soft paper towel with lighter fluid to remove excess spray adhesive from plaque Tips: - If the image of the final product appears light increase the pressure or the dwell time slightly (5-15 seconds). - If the image on the final product appears blurred or substrate appears yellowed reduce the dwell time slightly (5-15 seconds).

Price: 19.75 USD

Location: Roswell, New Mexico

End Time: 2024-12-30T22:54:22.000Z

Shipping Cost: N/A USD