Custom Hydroboost Socket for Large 4 Point Nut

Description: This a single socket kit being sold that requires the crows foot to be welded on the end for use in torquing. ****If you would like this shipped welded just message me at or after checkout requesting an additional $5 for the welding. The second picture shows how to fit the crows foot prior to welding. The third picture shows how to properly torque using a crows foot.***There is no need to remove your rod end or clevis with this redesigned socket.This socket is cut from DOM steel, is ~4" long and designed to remove/replace the four point nut from the back of your hydroboost in order to change mounting plates or brackets. It will fit every OEM Bendix/Bosch hydroboost and it is the only socket that will fit the custom built mounts I sell in other listings or the custom mount kits that I sell in other listings. This socket can be used on hydroboost that have the brake rod staked to unit as it permits the rod to protrude through the end of the socket. The nut size is 1 15/16” and the socket can't have an outside dimension greater than 2 1/4" in order to be able to fit into the recess of many hydroboost angled mounting plates. Just be sure you can re-torque it to the OEM specs of 110 ft/lbs., over torqueing can result in a cracked nut.****Note: These sockets are machined to fit the four point nut only. Your nut should have a retaining clip you will need to remove to install the socket. In every case the socket has been test fit to a new nut prior to shipping but it may be a little on the tight side. You may want to lightly tap the socket on the nut to ensure it is fully on the nut until the socket wears in. This socket was not designed for use with a pipe wrench, neither was any other part of your vehicle. If you stay within the torque values the socket will last quite a long time, I use one every day. If you exceed the torque values or don't have the socket fully on the nut and/or square on the nut you will shorten the life of this non-hardened socket. Shipping is figured for one item only, I'll work with you if you buy more than one and will only charge the USPS Flat Rate for however many I can fit in a box. ;) Shipping is quoted for CONUS (Continental US) only. I have shipped these to Thailand, Mexico, Russia, New Zealand, Brazil, Panama, Latvia, Spain, Turkey, Sweden, Quatar, Norway, France, Italy, Germany, Denmark, Dubai, UK, Canada, Greenland, Iceland, Australia and South Africa, but please contact me prior to purchasing so we can work out acceptable shipping arrangements. I will provide you with a shipping quote for you to consider PRIOR to your purchase. I will only accept paypal on purchases outside the US. I request that in the text of your message you indicate the country and postal code you wish the unit shipped to. Disclaimer: Hydro-Boost is a registered ® trademark of the Robert Bosch Corporation. All products herein are modifications and not directly or indirectly affiliated with the Robert Bosch Corporation unless noted. Custom Power Brake (aka Sterlingworth16) is not affiliated with Bosch. All products herein are designed for off road use only and are not DOT certified. The process to meet DOT certification is extremely lengthy. To my knowledge, no other aftermarket modifier of hydroboosts has their units DOT certified for street use either. Any purchase of product and/or use of tech related to these products constitute the understanding that brake line pressure will be dramatically increased and the acceptance of liability or risk related to use. Key words: hydrobooster, hydroboost adapter, hydro boost, hydro-boost, hydro-booster, hydraulic booster, brake booster, astro van, safari van, Jeep CJ, Jeep YJ, Jeep Wrangler, Jeep TJ, CJ10, Toyota FJ40, Dana 60.

Price: 80 USD

Location: Pilot Point, Texas

End Time: 2023-12-08T16:12:11.000Z

Shipping Cost: 15 USD