DJI Phantom 4 Mast Mount 4 positions for Camera GNSS or Remote ID

Description: Mount a GNSS antenae system or Remote ID on your DJI Phantom 4 series . Can be mounted in 4 positions up/down on front or rear (pictured on rear down position) Hollow Mast (included) accomadates a FLIR, Sequoia Multi spectral , Remote ID or any type of GoPro style auxiliary camera. Now includes Remote ID or component cover. Weights:Front / Rear Mounts 30-40gTypical mounting with fasteners for 1 device 6-10gTested Payload Limit 240g (GoPro Fusion) This is for Front/Top or Rear mounting on a Phantom 4 series using our unquie "V" Lock Mountingaccepting diameters from .625 to 1.1 inch. Easily mount a GNSS antenae on one end and a small cameralike the Action 2 on Front/Top The listed price is for one mounting system if you need front/top and rear order 2. Note- There are two base Phontom 4 models Original no senors except bottom .Later models have sensors on side, front ,rear and bottom. Specify which you have when orderingor mount may not fit. (also called Phantom 4 PRO) DRONE and Accessories NOT INCLUDED This mount is not a replacement for the standrad DJI front mount camera however you could use as your only camera if you do not have a front camera. COPYRIGHT © 2022 alienconcepts incorporated Multiple units are available MADE IN THE USA General for All Mounts We are constantly updating based on field use reports . As a result photos and instructions and components may changeat any time. Disclaimer We offer no guarantees that a mount will perform up to your expectations since there are too many variables.Use best practices for safe flying at all times . If unsure check with the FAA drone rules and regulations online.We assume no responsibility for any damage or injury because of the addition of one of our mounts. Payload Location and Clearance When mounting payloads verify against recommended weights and sizes for your drone in manual orcontact manufacturer If you mount anything on top of the mount make sure it has prop clearance a simple checking method is listed next: 1-Place your drone with props on and look down from directly above make sureyou have clearance with nothing protruding outside of the drone main body envelope into prop space 2-If you do have payloads in the body envelope or you are unsure make styrofoam size model and affix it with double stickor velcro. Manually move through its full range and make sure there is no interference with the props. SafeguardsUse a safety lanyard on your mounts. This is one I use : AmazonMIZUGIWA Stainless Steel Lanyard Cable Tether Safety Wire for Loss Prevention 2 Loops w/Quick Release Ring & Rubber Coating 12" Set of 10

Price: 49.9 USD

Location: Algonquin, Illinois

End Time: 2025-01-20T18:43:59.000Z

Shipping Cost: N/A USD