For Happymodel 2.4G ExpressLRS EP1 EP2 Open Source ELRS Ultra Small Remote

Description: Product Description If you have any questions, please contact customer service first, do not open disputes easily, thank you! Features: Based on PP RX,we have developed ESP8285 version of Nano 2.4GHz rx named EP1 and EP2 The RF module of EP1/EP2 is the same as PP RX, but using ESP8285 MCU So you can upgrade the firmware via WIFI which is very user friendly Usually you just need to power up the unit with the remote control turned off After a while you can find the ExpressLRS hotspot Connect to this hotspot from your computer or cell phone The password is expresslrs,then you can access 10.0.0.1 to upload the receiver firmware Specification: EP1 RX Type:ISM ESP8285 Processor SX1280IMLTRT Wireless RF Module 2.4 GHz Omni-directional T-antenna Frequency Range:2400 MHz to 2500 MHz Maximum receive refresh rate:500Hz Minimum receive refresh rate:25Hz Operating Voltage:5v Weight:0.42g(without antenna) Size:10mm*10mm*3mm Operating protocol:CRSF(Betaflight) Peak Gain:2.23dB 1*EP1_RX 1*40MM Antenna 1*90MM Antenna EP2 RX Type:ISM ESP8285 Processor SX1280IMLTRT Wireless RF Module SMD 2.4GHz Chip Ceramic Antenna Frequency Range:2400 MHz to 2500 MHz Maximum receive refresh rate:500 Hz Minimum Receive Refresh Rate:25Hz Operating Voltage:5v Weight:0.44g Size:10mm*10mm*6mm Operating protocol:CRSF(Betaflight) Peak Gain: 3.7dB 1*EP2_RX Frequency Pairing Procedure After plugging in the USB for the first time,disconnect the USB as soon as you see the LED go out Repeat this procedure once and on the third time the USB is plugged in,the LED will begin to double flash This indicates frequency pairing mode 2.Connect the ES24TX module or DIY 2.4G ELRS HF head module to the remote control correctly Copy the ELRS.LUA file to the SD Card/Scripts/tools directory on the SD card of the remote control Then run ELRS.LUA to execute the binding operation 3.After successful binding,the LED will turn to normal light At the same time,you can receive telemetry signal 4.Meaning of LED status PP:Always on,frequency pairing is successful or connection and communication are normal LED double flash indicates successful frequency pairing,LED slow flash indicates unable to receive transmitter signal EP1/EP2 Frequency pairing is successful or communication is normal,LED double flash for pairing frequency LED slow flash cannot receive signal LED fast flash for wifi communication mode,at this time you can update the program through the computer or cell phone connection Package Includes: 1*EP1 module Or 1*EP2 module Note:Only include the above package productsSpecifications are manually tested and are for reference onlyPlease allow 0-1cm error due to manual measurementPlease make sure you dont mind before biddingDue to the difference between different monitorsPictures may not reflect the actual color of the item.Thank About Us We accept all payments authorized by eBay. About Us We accept all payments authorized by eBay. powered by

Price: 21.31 USD

Location: KEARNY, NJ

End Time: 2024-12-04T08:24:57.000Z

Shipping Cost: 0 USD