Striped Halo Ring Bolt Racker Handle for Ruger series Mark III, IV, IV Lite

Description: Introducing the Two-Tone HALO RING bolt racking handle, compatible with the Ruger Mark III, IV, or IV Lite.*This is for your ruger pistol's bolt and follows ALL ebay guidelines.**Fits the OEM/factory bolt* This bolt ring is not only practical, it also adds a splash of style to your pistol.Custom designed for maximum comfort, ergonomics, style, and reliability! FEATURES:Style: Looks gorgeous on any frame, pick a matching color or mix it up! Comfort & Ergonomics: The ring is minimal yet has maximized area where it counts, and contoured angles to allow for fingers to easily slide in and be used comfortably.Reliability: Most designs rely just on screw pressure to secure it, this halo ring has been custom designed with anti rotational tabs, catch ribs that align into your bolt, and a unique design to ensure maximum retention and reliability!*Bolt, nut, washer, AND hex key wrench are included!* EASY INSTALLATION: FOLLOW INSTRUCTIONS:*Works both ways up or down, your choice. *Make sure the flat part of handle lines up completely flat with rear of bolt. - I recommend getting one corner fully on, and then get the back flat against bolt, then you should feel the other corner cinch into place as you apply pressure if done correctly. Verify the back is flat against bolt before continuing. *Then insert the bolt/nut/washer and tighten it down. (don't over tighten, just secure it). **This listing is only for the charging handle, bolt, nut, washer, and hex key wrench. Any other items in the photos are for demonstration purposes only** *Disclaimer: colors may not match your frame, they are as is pictured. the green is an OD green, and the brown is a LIGHT army brown/fde color.

Price: 9.95 USD

Location: Spokane, Washington

End Time: 2025-01-17T23:28:45.000Z

Shipping Cost: 4.99 USD