Temp Twister Lid for BrewZilla, Digiboil, Bucket Buddy Fermenters 35L / 9.25 Gal

Description: This flat lid with pre-drilled holes allows you to easily add a Temp Twister Cooling Coil to your 35L Bucket Buddy fermenter. It also has holes for your stopper & airlock (included with the Bucket Buddy) as well as a Thermowell so you can control the circulation of cooling solution with a Temperature Controller. The lid is also compatible with 35L BrewZillas and DigiBoils. If you're fermenting in the Bucket Buddy with built-in heating element, we recommend plugging the unit into the heating outlet of your temperature controller and leaving the power switch turned on. This will allow the temp controller to provide power to the unit only when heating is needed and it will cut the power as soon as you're back to your set temperature. Using the Bucket Buddy's controller to maintain the heating set temp and using a separate controller to maintain the cooling may result in heating and cooling cycling at the same time. NOTE: The pre-drilled holes are meant for specific sizes of Duotight bulkheads and the stopper included with the Bucket Buddy fermenter. All holes need to be occupied in order to protect your fermentation from outside contaminants. Depending on the placement of the Temp Twister, you might need to shorten the inlet/outlet tubes on the outside of the fermenter using a Pipe Cutter. Lid only. Other accessories must be purchased separately. You Will Also Need: Temp Twister Cooling CoilFermZilla ThermowellTemperature ControllerKegLand Part Number: KL28103Or use it to convert your Robobrew, Grainfather, or Digiboil into an amazing stainless temperature controlled fermenter! Does not fit the Brewer's Edge Mash and Boil.

Price: 36 USD

Location: Lansing, Michigan

End Time: 2024-08-14T14:49:37.000Z

Shipping Cost: N/A USD